Kanger T2 coil

Replacement coil for rebuildable KANGER T2 clearomizer.

Changing the coil of the T2 clearomizer:

• Unscrew the drip tip mouthpiece
• Unscrew the coil
• Screw on the replacement coil 

Choice of resistance or impedance value:

The lower the resistance value, the more heat produced, which increases the hit (sensation of vapour passing down the throat), the amount and temperature of the vapour.

The first reflex is therefore to choose a coil with a low value to have a maximum of very warm vapour and this reasoning is correct... but don't forget that in this case:

• Your battery will discharge more quickly
• You produce more vapour but consume more e-liquid
• Your coil clogs up and wears out more rapidly
• You risk having a burnt taste due to over-rapid vaporisation of the e-liquid.

Summary table of resistances to use in relation to your battery voltage:

• 1.5 Ω: 3.3V to 4.2V battery
• 1.8 Ω: 3.6V to 4.5V battery
• 2.2 Ω: 3.7V to 4.8V battery
• 2.5 Ω: 4.2V to 5.5V battery
• 2.8 Ω: 4.4V to 6V battery

Please note that batteries at a constant voltage such as the evod and eGo have an output voltage of 3.7 volts Give priority therefore to resistance values of between 1.5 and 2.2 ohms.

For variable voltage batteries (Spinner, Aro or Aspire). The value of your resistance is less important as you can adjust the power of your electronic cigarette by varying the voltage. If your resistance is too low, you can lower the voltage and inversely, if the value of your resistance is too high, you can increase the voltage.

When should you change your coil?

As it heats up, the coil transforms the liquid into vapour, but a deposit forms and clogs up over time. Result: the coil heats less, produces less vapour, and the deposit gets into the liquid due to the effect of the heat.

A drop in vapour production, less flavour produced, and a dark colouration of your e-liquid are signs that your coil needs changing.